Do you have a question? Post it now! No Registration Necessary
- Posted on
- Thin client case for microatx motherboard
February 6, 2004, 4:05 am
rate this thread
Re: Thin client case for microatx motherboard
Perhaps the mini-itx (17cmX17cm) form factor would better interest you.
Smaller than micro-atx and less heat. Unless you need barn-burning
performance, the Epia M-10000 is a pretty decent integrated board. The
2699 cases are about the size of a VCR and still fit a regular PCI card
by using an included riser to rotate the card 90 degrees. A regular
3.5" hard drive fits, as well as a regular floppy. The only real
drawback is that you have to use a slim-line laptop CD/DVD drive.
- » Atmel STK500 beginner Flash mem verification problem
- — Next thread in » Embedded Programming