Appears to be two lead, multi-stranded hook up wire with 1.25mm diameter PVC jacket. Short of stripping and measuring the wire itself, is there any way to tell what gauge it is with the information provided? Thank you.
1.25mm is 0.049 inches. That includes the insulation? And presumably, that is only one (1) lead? Nothing is written on the wire itself?
At a S.W.A.G., allowing the PVC to be somewhere at /around 0.30 mm of the total diameter +/-, that would put you at 20 gauge AWG, or so (0.9mm). Given that the most common wire gauges found in the USA are even numbers, the options are 22, 20, & 18. 18-gauge is too thick unless the PVC is very thin. If thick, then 22 gauge is most likely.
Peter Wieck Melrose Park, PA
You could get a rough idea of the diameter and stranding by measuring the dimensions visible across the cut end.
..but the answer is no. Anything but an electrical/physical measurement or labelled specification is guessing.
RL
ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.