> The hoses are a tight slip fit in the holes in the tank .
>
> OK. Good. That's what I was hoping. The larger yellow hose coming out the
> top of the carb is pulled out cleanly so am I to conclude it's the return?
>
> > The supply
> > line will usually have a filter on the inside end .
>
> The smaller greenish blue is the one that broke at the tank edge so it's
> currently blocking the hole (I can probably pick it out though).
>
> Am I to assume that's the input fuel line to the carb?
> > I install them by
> > cutting the end of the hose at a long taper to get it started in the
> > hole , pull it in as far as needed with long nose pliers or a hemostat
> > then cut it off square and install the filter.
>
> I hadn't thought of the filter. It must be still inside the tank.
I sometimes think back to when I was a kid fooling around gas tanks and hoses, etc. I remember a mesh. And I remember removing it. That must have been a filter. Damn. Geez.