In replacing the wig-wag/solenoid unit on my Whirlpool belt drive washing machine, I inadvertently tore the wires off the two solenoids before labeling them. The wires are undamaged, and I was able to replace the unit, but now I am unsure which wire goes where. There is a red wire which I believe is for the spin cycle solenoid, a yellow wire which I believe is for the spin cycle solenoid, and two white wires which I presume are ground. But I am not completely sure that is right, and I am not sure if it matters which contact on each solenoid is load vs. ground.
Can someone tell me which wire goes where?
Thank you, Eric