Like it states.. I've reversed engineered som of the board but it would be nice if I had an offical schematic to this Furman AR-1220 120V like regulalor...
Currently what I have found it the control transformer to P3 plug seems not correct to me.... It is using a 230v primary in a 120 V system and is part of the supply rails for the 5, 15+ and 15- post regulators..
Its only getting to 10VDC after the bridge on the average and of course that isn't enough for proper reg..
I put in a temp transformer that would deliver the correct amount but then it places the unit into EVS mode (Extreme Voltage Shutdown) and never comes out of it, yet it seems to appear to operate with rails saging on the 15 volt supplies.. These supplies are to take care of the TLO84 quod opamp and thus the way they are now tells me the 15 volt regs are nothing more than limiters not regulators...
So does anyone have a source to the schematic ?