MIssion cambridge amplifier

On Nov 18, 9:29=A0am, Cees Keyer wrote: > Dear All >

And you deleted the pix from the memory card too? When the computer is repaired get a USB drive to back that stuff up. Sorry I can't help with the amp.

G=B2

And you deleted the pix from the memory card too? When the computer is repaired get a USB drive to back that stuff up. Sorry I can't help with the amp.

G²

Yes, I thought that it was odd that the pix had gone from the camera as well. Memory cards are so cheap now that I never delete anything from my camera. When the card gets full, I just replace it with a new empty one, and archive the full one away as my 'negatives'. Sorry also. I don't have any info on the Mission, but it can't be that hard to reassemble correctly, can it ? Most decent equipment uses different sized or shaped connectors at each point, to preclude the possibility of refitting them incorrectly. Also, after years of laying and being ty-wrapped in one place, a harness will normally re-lie round about where it should be, if offered back in, and it will be obvious where each connector goes. As a matter of interest, why did you find it necessary to dismantle to this level in the first place ?

Arfa

snipped-for-privacy@d42g2000prb.googlegroups.com...

Yes i deleted the pictures of the memory card as well.

I took it apart due to the awkward ticking noise it made. Every 4 5ish second it made a tick sound, so the power supply was taken out for checking the capacitors on ESR and leakage. It is quite compact build so the inter pcb wiring was removed from the pads. And i can't figure it out where what wire came from. Schematics or service information is not available, even from the distributor in the Netherlands.

Cees

Ah, I see, you had to unsolder the wires. That explains it. Well, if it's just the power supply to main board harness in a preamp, there surely can't be that many wires, can there ? What is there - a ground or two maybe and a positive and negative rail pair for the opamps ? As you know where the wires go to at the preamp end, assuming that they are still attached to the preamp board, then it shouldn't be difficult to determine where they came from on the power supply. I'm willing to bet that if the loom had been in there a long time, it's going to have formed itself into some sort of shape that it's probably still fundamentally got. That should at least give you a clue as to the general area that each wire goes to.

Arfa

Model number?

MOdel number is 778 tnx in advance

If you haven't filled the card with new photos, this software can work wonders - as it has for me.

G=B2