Hey, guys Aforementioned TV has resistors R504 and R524 burned beyond recognition. Can anyone help me out with the values of these components? Looks like C432 is about to blow its top as well. Thanks,
voMEo
Magnavox mdl RS2568C602 27" TV circa 1993
Mar 21, 2005
1 Replies
Don't have schematic handy to look up the specific resistor numbers, but pretty common for 130V supply filter to go bad. Replace with low-ESR 100uF 200V or 250V. When this cap goes bad, regulation is lost and the horizontal drive supply resistors run hot and de-solder themselves. There is some variation in value depending on model, but most of them are
68K. These resistors will take a lot of punishment, and usually survive even if the printing is burnt off. Check the value, replace if necessary, or at least clean the leads and pads and re-solder.Damage may pr> Aforementioned TV has resistors R504 and R524 burned beyond
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required