I've read several descriptions of renovating zebra connectors, but they've all been for small LCD's.
Has this been done successfully for large displays, such as laptops & desktop monitors?
And yes, I'm sure it's the zebra and not a driver signal issue.
Thanks.
desktop
Are you talking about traditional rubber/metal sub-mm sandwich zebra strip or the newer micron scale anisotropically conductive tape?
-- Diverse Devices, Southampton, England electronic hints and repair briefs , schematics/manuals list on
On Mon, 3 Aug 2009 02:15:39 -0700, N_Cook wrote (in article ):
Hmm... don't know. 8-year-old laptop 14.1-inch tft xga lcd display. I presumed alternating insulator/conductor rubberized strip. How "new" is the tape technology?
On Mon, 3 Aug 2009 07:52:46 -0700, notme wrote (in article ):
That is to say, I haven't opened it up yet to look.
What is the likelihood that this age display will be zebra type?
Thanks.
I'd bet that it's not a zebra.
If you've got lines out, you can try to press it down with a thumbnail or something similar to get the flexible circuit board stuck back to the glass. Then shim behind it to keep the pressure on. I've had some luck reducing the number of lines out, but rarely fixed 'em all. The second attempt always resulted in making it worse.
I think removing and replacing the whole connected section is not practical without fixturing. Sideways alignment is critical.
ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.