Hey,
I have a puls generator mentioned above.
The settings for the impuls frequency and width and so on work fine but there is a problem. If I set the the impedance on 10kOhms I only get 4V amplitude instead of 19.99V and at 50 Ohm there is only 200mV instead of 9.99V. I have not found anything to change this behavior! Also there is shown an error message "PARAM" if I press the High Level (HIL) botton or the Low Level (LOL) botton. The DC-voltage is on the 0-line at about -7.5V and oscillate 300mV up and down.
If there is someone who knows what is wrong please let me know!
best regards Peter