Guitar amp input socket replacement

MilesG · 2007-01-13T14:47:19+00:00

I am trying to locate a 1/4" TRS input socket replacement for a Hohner Panther Tega-10 guitar amp. I have removed the damaged one by melting the 4 solder points where the narrow pins at the end of each leg fix into the circuit board. These are spaced 16mm apart (measuring side to side across the amp) and 13mm apart (measuring from front to back, i.e. in line with the jack). The height of the centre of the jack to the surface of the circuit board is 11mm.Can anyone please suggest where I might find one?MilesG (UK resident)

Jan 13, 2007 22 Replies

Rate this thread:

MilesG 19 years ago

Yes thank you Ron; that's very helpful. 2-pole it is then. How critical is the gauge of the copper wire or flexible wire? I have a short length of twin core and earth still attached to a discarded light switch - at about 1mm is the bare earth thick enough? It seems sturdy enough. Miles

Vote

Ron(UK) 19 years ago

Not critical at all, the copper cores out of twin and earth is probably ideal.

Ron(UK)

Vote

MilesG 19 years ago

I'll let you know how it works out in due course. I'm most grateful. Miles

Vote

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required