Grundig Satellit 500, only works on FM

Hi, it may be a long shot:

Has anyone come across this problem? Only FM works. Main supply voltage OK. It's not the antenna switch.

Also, where do I get schematics/service manual? I found a copy but hardly readable.

Cheers

Tony

Reply to
Tony
Loading thread data ...

-----------------

** A couple of minutes with Google turned up this:

formatting link

See the second post.

Seems loss of all AM bands is a common fault caused by a dodgy trim cap - C138.

..... Phil

Reply to
Phil Allison

Thanks Phil, I read right past this clue and missed it. However, it was not C138, but another one nearby, C130. They are not on the RF board but on the processor board underneath (in a can...).

It's easily identified by the fact that it is actually accessible through a hole in the RF-PCB above and in the can below. There is a handy hint for any one chasing this fault!

If one doesn't want to go so far and actually replace this trim C there would be *no need* to take out the RF board, unsolder and bend out the 4 lugs of the shield cover of the processor boards and so on, a real PIA. Just reaching through the hole with a trim tool and lightly tapping on the variable cap is a quick fix. Good enough for me for now, I'll see how it goes. But if one needs to replace the lithium memory battery there is no way around this awkward job though.

Tony

Reply to
Tony

ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.