Hello, I've been working on an acoustic guitar with a built-in fishburn pre- amp. The pre-amp has one input cable coming from the strings of the guitar, and I believe these are probably piezo-electric devices. There is another cable which goes to the 1/4" output jack of the guitar. The problem is that when the guitar is plugged into an amplifier (this is not the pre-amp), there is a loud and consistent humming. If I put my hand on the strings or on the output jack, the humming stops. I was told that this was a problem with the pre-amp. But I did some checking and found that I could disconnect the cable (which connects the pre-amp to the output jack) and the hum is present.
So, now my circuit consists of the guitar amplifier, the cord (20'), the output jack of the guitar, and a three wire cable (20 gauge, I think) which is soldered to the output jack on one end and has a 3 pin plastic socket on the other. That's the whole circuit and I still get the hum. I unplugged the guitar cord from the output jack to see if the hum was in the amplifier, and it wasn't. The hum is only present when I have the guitar cord plugged into the output jack of the guitar. So it appears that the cable is acting like an antenna.
Can anyone explain how this 18" cable is causing the hum? And how can I fix it?