Hi,
Fault was monitor cutting out in use, found this was due to IEC mains socket soldered to PCB becoming loose, cure was to re-solder socket to board.
Hardest part was getting to the PCB, hence these notes.
- Remove pedestal screws (2 long) and back screws (4 short 1 medium).
- Prise back cover off, exposes metal cage over PCB.
- Remove multiway plug on right.
- Peel back self-adhesive foil covering four two-wire plugs, note wiring colour/order then remove 4 plugs.
- Prise front plastic bezel off.
- Remove 4 countersunk bolts holding LCD to frame.
- Remove LCD ribbon from slot (pull gently).
- Remove LCD panel.
- PCB now exposed, remove black plastic plug locating IEC socket.
- PCB can now be unscrewed.
Regards, John