I have a Generac transfer switch sub panel that was made to be used with a an automatic controller. I do not have nor do I want the controller. Inside the box is the transfer switch that can be actuated manually or electrically. The switch has two solenoids and two snap action switches. The solenoids are rated for 240 volts. The switches for 600 volts. I want to use a momentary contact rotary switch to actuate the solenoids. I am not sure how the snap action switches are wired yet but I think theyare already wired the way I want them to be. I want the snap action switches to remove power from the solenoid that is being powered to cause the transfer switch to move. That way once the solenoid has done its job it will no longer be powered no matter how long the rotary switch is held in the on position for that particular solenoid. I don't see a problem with this. Is my scheme OK? Thanks, Eric
- posted
3 years ago