11 discussions on ElectronDepot about the Freescale MPC5200: what owners asked, what went wrong, and what fixed it.
Hallo,irgendwo hatte ich gelesen, das man den CAN-Bus als Software in beliebige Prozessoren mit einbinden kann. Vorausetzung sind dabei die ausreichend vorhandenen Ports am Prozessor.Leider finde ich dafür keine brauchbare Quelle. Kennt...
HelloI'm trying to choose a microcontroller for an automotive application.I spent couple days digging through lots of pdfs but...I'm just a programmer;) Now, for the first time, I have to choose mcu so I thought asking for help of more...
I'm trying to interface to a MAX11043 (4-channel synchronous ADC with SPI output). It has an end-of-conversion pin, which when active means that a bunch of data is available to read via SPI.Which is fine, except I want to run this baby at...
Hello! I've been looking at developing some handheld test equipmentfor my lab (think small portable oscope) and I'd like to have it runlinux. I've worked extensively with the AD Blackfin in the past, buti'd like to run something with an...
Hey!Im working on a Kontron MOPS/520 embeddede computer (133 MHz AMD SC520 386-arch). Kontron has an onboard Intel 82527 CAN-controller. I am looking for a Linux-driver for this device (CANOpen). The Linux kernel ver is 2.4.20-20.9.Thanks...
I have a Freescale MPC5200 board I designed a while ago whichcomes out of reset (I am writing the flash with a debug monitorwhich has served me over the years - I wrote it first for the 68020,thenI made a CPU32 version, then an MPC8240...