Hi All, Currently, I am using Embedded Planet's EP405 development board. I would like to use a USB device with it, but there is no USB connection on the EP405 board. So I connect a PCI to PC104-plus adapter to the EP405, then connnect a PCI to USB 2.0 card. But right now the USB driver is complain about it can't not get a irq.
I have tried to move the jumper on the adapter to different setting, but there is no use. Also, I have changed the register on the EP405 board to the appropriate setting, like enable local PCI IRQ controller and changed the PCI (INTA compliment) to enable. But it still not working.
Have anyone does anything similar to this or can give me hint or pointer? I am running out of idea.
The following is the info and the bootup log
kernel version : 2.4.22 download from
usb.c: registered new driver usbdevfs usb.c: registered new driver hub hcd.c: Found HC with no IRQ. Check BIOS/PCI 00:0a.2 setup! host/usb-uhci.c: $Revision: 1.275 $ time 18:49:57 Sep 16 2003 host/usb-uhci.c: High bandwidth mode enabled host/usb-uhci.c: v1.275:USB Universal Host Controller Interface driver host/usb-ohci.c: found OHCI device with no IRQ assigned. check BIOS settings! host/usb-ohci.c: found OHCI device with no IRQ assigned. check BIOS settings! usb.c: registered new driver hiddev usb.c: registered new driver hid hid-core.c: v1.8.1 Andreas Gal, Vojtech Pavlik hid-core.c: USB HID support drivers Initializing USB Mass Storage driver... usb.c: registered new driver usb-storage USB Mass Storage support registered.
The following is the info I got from /proc after it boots up.
PCI devices found: Bus 0, device 10, function 0: USB Controller: NEC Corporation USB (rev 65). Master Capable. Latency=128. Min Gnt=1.Max Lat=42. Non-prefetchable 32 bit memory at 0xbffff000 [0xbfffffff]. Bus 0, device 10, function 1: USB Controller: NEC Corporation USB (#2) (rev 65). Master Capable. Latency=128. Min Gnt=1.Max Lat=42. Non-prefetchable 32 bit memory at 0xbfffe000 [0xbfffefff]. Bus 0, device 10, function 2: USB Controller: NEC Corporation USB 2.0 (rev 2). Master Capable. Latency=128. Min Gnt=16.Max Lat=34. Non-prefetchable 32 bit memory at 0xbfffdf00 [0xbfffdfff].
and the following is the info I get after I mount the usbfs and look at the driver file
usbdevfs hub 96-111: hiddev hid usb-storage
Thank you very much
Shih-Ying Chou