PCB UV Box - Follow Up

Aly · 2007-04-07T18:50:22+00:00

Hello,First off, thank you to every one of you for answering the other thread.It's given me plenty to research and perhaps over analyse.I think I'm going to go for the ready kit put together by Rapid, this iswritten up below. But before I do that I'm left wondering something..Where I have my nails done they use one of the little UV boxes. They'rehere on eBay;Now what I'm wondering is. Would one of those do the job? Or more to thepoint, would it be cost effective to strip one down and use the parts.Thereafter ALL you need is an enclosure and some perspex. Also today it'sbecome clear regarding 4mm glass that suppliers either only stockUV-blocking glass, or don't even know at all. No one knows what they'reselling anymore or even cares!! This is the UK, it's a dump full of underachievers and everyone has a degree in Travel & Tourism or Marketing,everyone else is on state benefits.So.. The nail box up above? :-)Warm thanks,AlisonThe following will need to be viewed in a fixed font such as Courier to allline up;"Sourcing a UV Exposure Box for PCB Development.-----------------------------------------------0. Introduction1. What's For Sale?2. Ultraviolet exposure unit with timer 202E3. Ultraviolet exposure unit with timer 202E - Starter Kit4. UV tubes available on eBay5. Flight case style enclosures6. Minimum parts required7. Conclusion0. Introduction---------------I wish to start developing PCBs using the Photoresist and UV Developmentmethod. In the past I have used a Dalo pen and drawn everything out, usingferric cloride to etch the copper off. I would like to design more complexcircuits on a PC and print to transparancies.The immiediate requirement is to source a UV Development box. There are twooptions; Build One; Buy One. When considering building one the light outputhas to be in the range of 400nM. There is absolutely no point inapproaching DIY outlets as they have haven't a clue what you're talkingabout (I've been out hunting today). Blacklight dark...

Apr 07, 2007 21 Replies

Rate this thread:

Coyoteboy 19 years ago

Leon proclaimed to alt.electronics ...

What do you use to sensitize the board? Or do you buy presensitized?

J __________________________________________ http://www.jbuckle.homeip.net

Vote

Aly 19 years ago

Hi Leon,

Noted. In the end I bought the one on eBay. But still have an idea about an LED UV box for the small size.

Aly :-)

Vote

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required