How to design...

Here's a thread on the forum:

formatting link

What I need to figure out is how to design so the 2 bit binary output changes each time the user powers off the Atari 2600 and then back on.

Basically the design will have 4x Atari games burned onto one EPROM and installed on one cart and each game would cycle with the power switch.

Since the 2600 cart port only has A0-A11, enable (active high, requires inverter to work with EPROM /OE line), 5v, and ground there is no reset or anything so using push button to cycle the game won't work, it'd simply crash the system. Using DIP switch to select one of

4 seems the best solution (and has been used before) but is there an automatic game selection?

Thanks.

--
To reply, replace digi.mon with tds.net
Reply to
Impmon
Loading thread data ...

ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.