Uses Philips ARM LPC2106 microcontroller with 128kbyte Flash and 64kbyte SRAM.RTC, 2x UARTs, I2C, SPI, 2x 32bit TIMERS, 7x CCR, 6x PWM, WDT, 5V tolerant I/O, up to 60MHz operationRTC, 2x UARTs, I2C, SPI, 2x 32bit TIMERS,
7x CCR, 6x PWM, WDT, 5V tolerant I/O, up to 60MHz operation- Two on board voltage regulators 1.8V and 3.3V with up to 800mA current on-board.
- Reset chip included on-board.
- expansion headers (back) for uC pins
- 12.X MHz oscillator on-board.
- USB power cable
- Serial cable for program uploading
a.. RS232 interface circuit b.. RESET circuit c.. push BUTTON with pullup d.. status LED e.. Boot loader enable jumper and pullup f.. DBGSEL, RTCK pullup resistors g.. single power supply from USB: +5-9VDC required h.. prototype PCB area with +3.3V and GND bus i.. Power plug-in pole j.. PCB: FR-4, 1.5 mm (0,062"), soldermask, white silkscreen component print k.. Six mounting holes For more information see the arm board home page at
formatting link
mcu developement team