Hi all,
We are working with a Memec development board with a Xilinx Virtex-II Pro FPGA. The idea was to run VxWorks on this board. But we seem to have a bit of problems. And it seems very hard to find resources on the internet that uses VxWorks with Xilinx FPGA's.
So I was hoping that anyone here could suggest some places to look out.
Also right now we do not have the com module, so no ethernet and no flash. But we load the SDRAM with the vxworks executable and then jump to that address. Is that a good way, or do you have to go through some ROM-loader?
All help would be greatly appreciated!
With regards Jonas Floden