Hey folks, I need help regarding qspi flash boot with zynq .
1.I am using ZYNQ part number xc7z014sclg484-1 (active).
2.Software used:vivado 2019.1
- qspi FLASH :W25Q128FWSIG
3.I am doing the qspi flash boot without DDR.The following procedure mentioned in
formatting link
used by me.4.My FPGA VHDL code is blinking the led.
- In sdk I am using helloworld program as a simple application program.
- Bit stream is working successfully but helloworld.elf file is not loading in flash.
So could anybody tell me the procedure to make FSBL?