Hand-soldering a custom keyboard from bare purple boards

Nov 18, 2026 Last reply: 1 day ago 2 Replies
Jump to replies (2)

Anyone who has wanted a keyboard laid out exactly their own way knows the gap between a finished schematic and a working unit on the desk. That gap is what this build closes. It is the eighth part of a series on designing and building a custom keyboard, and this stage follows the whole assembly run: parts arriving, soldering, testing, software and final case assembly.



The purple PCBs are inspected for fabrication defects before any component goes on. Under a digital microscope the maker checks traces, pads and surface finish, then solders a 12 MHz crystal onto pre-tinned pads, a miniature four-pad RGB LED, two indicator LEDs, and the mechanical switch hot-swap sockets on the reverse side. Threaded metal standoffs are reflowed into their mounting rings with hot air, three rotary encoders drop into through-holes, and nine switches with clear housings and pink stems seat into the sockets through a black CNC metal plate.



The testing discipline stands out to me. The power rails are probed in both polarities to rule out shorts, the regulated rails measure 5.037 V and 3.274 V, and a USB power meter between a USB-C source and the board reads roughly 5.06 volts and 0.04 amps while the status LEDs illuminate. After that, firmware and a VIA layout file are pulled from a repository, and RGB colors plus custom shortcuts get configured on the finished keyboard.



Everything is shared too: the EasyEDA project, GitHub hardware, 3D and software files, and a Thingiverse model are all downloadable. Bonus videos covering QMK customization, custom case images and 3D design are planned but not recorded yet, and whether they appear depends on time, views and viewer interest. I hope they do.



Project by Robert Feranec. Watch it on their YouTube channel:

formatting link


How did the maker attach the threaded standoffs? Are those screwed in from the underside of the board or fixed some other way? A joint like that on a thin mounting ring always worries me, and I would like to know the exact method used before attempting anything similar myself.

The threaded metal standoffs are reflowed into the mounting rings using hot air, so no fasteners are involved in that step. The hot air reflow is the attachment method shown, done with the Atten hot air rework station that also handles reflowing the other components on the board.

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required