A Minimal ESP32-S3 Board Straight From the Datasheet

Nov 16, 2026 Last reply: 17 hours ago 3 Replies
Jump to replies (3)

The detail that jumped out at me first: the external 32.768 kHz RTC crystal is gone from this design entirely. Starting from the reference schematic on page 42 of the official datasheet, the maker trimmed it down to a bare bones board around the ESP32-S3-WROOM-1 module. In my view that is the boldest trade-off here, and it makes the whole thing a clean starting point for anyone's own PCB designs, which is exactly how the maker describes it.



The build path is refreshingly straightforward. Everything was drawn in KiCad with the official Espressif library, routed over two copper layers with 0.4 mm tracks for power and 0.2 mm for the default signals. Stitching vias went in, ground planes were poured, and the parts were arranged around the central USB port and the module. The dimensions and pinout spacing were checked in KiCad's 3D viewer, where the layout turned out to sit happily on joined breadboards. Gerbers and drill files were zipped up and sent through the fabrication service's quotation tool, with the order set for black solder mask and white silkscreen.



Plenty of small decisions stand out. The native USB OTG pins, GPIO19 and GPIO20, take the place of a USB-to-UART bridge chip, and pull-down resistors sit on the Type-C CC1 and CC2 lines. The LD1117S33TR regulator was picked for its compatibility with multi-layer ceramic capacitors, which seems like a smart call to me. An RC delay handles the enable pin, two tactile buttons cover reset and boot, two 20-pin headers break things out, and three surface-mount LEDs in red, green and blue sit on 5V, 3.3V and GPIO21.



What I keep wondering is how the board behaves in the real world without that crystal. The files are shared in a GitHub repository, so anyone can load them up and find out.



Project by atomic14. Watch it on their YouTube channel:

formatting link


Picking the regulator specifically for compatibility with multi-layer ceramic capacitors is the cleverest bit here in my opinion. A lot of first boards get caught out by regulator stability with those caps, and choosing a part that avoids that headache keeps the bill of materials simple. It also fits the whole spirit of the design, since every choice seems aimed at keeping the layout easy to copy.

Question about the RC delay on the enable pin: what values did the maker end up using for the resistor and capacitor, and how was the timing worked out? I have seen quite a range of choices on similar boards and it would be useful to know what landed on this one, especially since the datasheet schematic was simplified rather than copied as-is.

One improvement worth trying: route the USB data lines as a matched pair with equal lengths. At the short distances on a board this small it is probably not critical, but it costs nothing to do while laying out, and it makes the design more robust if someone stretches the traces or adapts the layout for a larger board. It would be a nice addition to an already tidy two-layer routing job.

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required