Embedded Programming

SED1335 LCD Controller: Screen Disturbance

Hello all, I've been using this chip (built into an LCD module) for a while and have the LCD inverted, i.e. background...

13 comments posted 20yrs

posted by raphillips

13 comments posted 20yrs posted by raphillips

JTAG - Boundary Scan s/w using Byteblaster or Parallel 4 cable

Does anyone know of any software, ideally freeware, which can use the above JTAG interfaces to exercise other JTAG inte...

6 comments posted 20yrs

posted by fred

6 comments posted 20yrs posted by fred

PIC migration timing problem

Hi, can anyone advise please? I've migrated code running on a PIC16C54 to a PIC18F1320. Both use an external RC network...

11 comments posted 20yrs

posted by simon

11 comments posted 20yrs posted by simon

Linux or NetBSD on my Linksys BEFW11S4

Hey everyone, I'm trying to get either Linux, NetBSD or some kind of Unix running on my Linksys BEFW11S4 embedded route...

3 comments posted 20yrs

posted by khanzf

3 comments posted 20yrs posted by khanzf

Need help for developing a SCSI hard disk driver

Hello, First of all, here is a description of the hardware. The microprocessor is a Freescale PowerQuicc8270, connected...

5 comments posted 20yrs

posted by bobione44

5 comments posted 20yrs posted by bobione44

Simulate SD card by a microcontroller

Hello all, Is it possible to simulate/emulate a SD card by a microcontroller/computer with a harddisk in such a way tha...

0 comments posted 20yrs

posted by joskamp18

0 comments posted 20yrs posted by joskamp18

First ZigBee co-processor chip from Ember

Draws only 1uA sleep current. It's a ZigBee co-processor (that's ZigBee with a capital 'B', gang) that interfaces to mo...

11 comments posted 20yrs

posted by editor1

11 comments posted 20yrs posted by editor1

Is avrfreaks.net down

have been trying all morning Thanks

3 comments posted 20yrs

posted by surftom

3 comments posted 20yrs posted by surftom

An example of an embedded system with block diagram

Hi ! Can anyone please guide me to some site or if anyone can please mail me the following I shall be very grateful ! I...

5 comments posted 20yrs

posted by junaidnaseer

5 comments posted 20yrs posted by junaidnaseer

Difference Between CAN Mute Fault and CAN Bus Off Fault

Hai all, Can any one please give the me more details about CAN Mute and CAN Bus off Faults. I thick CAN Bus off is noth...

0 comments posted 20yrs

posted by maddukuri.rajesh

0 comments posted 20yrs posted by maddukuri.rajesh

AT91SAM7A3 real-time timer

Hi, I see in the datasheet of the AT91SAM7A3 that the real-time timer (RTT) is fed by the Slow Clock, which is an inter...

3 comments posted 20yrs

posted by cucafera

3 comments posted 20yrs posted by cucafera

VLIW ASIP

Hello all, Please, check one or more of the following which can be classified as ASIP based on VLIW. [ ] TI C6x [ ] Age...

5 comments posted 20yrs

posted by russomiche

5 comments posted 20yrs posted by russomiche

USB 2.0 High speed 480Mbit device controller

Hi, It seems I can't find anything else than CY7C68013? With the plenty of USB 2.0 High speed devices around novadays (...

2 comments posted 20yrs

posted by tusunov

2 comments posted 20yrs posted by tusunov

High Speed ADC and DAC

I require high speed ADC and DACs which should operate at around 100MSPS for Broadband applications. The ADC and DACs s...

2 comments posted 20yrs

posted by gajendraph

2 comments posted 20yrs posted by gajendraph

DDR SDRAM

Hi all, I'm designing an FPGA based board. I needed to add DDR-SDRAM. Is there a way to interface the SDRAM to the FPGA...

2 comments posted 20yrs

posted by taileb.mehdi

2 comments posted 20yrs posted by taileb.mehdi