Embedded Programming

  1. Home
  2. Embedded Programming
16390 Threads Posts
to

Worth reading in Embedded Programming

ucos-ii and arm

Hello can anyone give me small examples to port ucos-ii on arm lpc2106 and how to write bsp
1 comments posted 19yrs
posted by bhangadesanjay
1 comments posted 19yrs posted by bhangadesanjay

MMC LCD Interfacing in ATMega16

Hi Can someone lead me to some tutorial or some sample codes to write data into my MMC, read & display onto LCD. I'm usi...
6 comments posted 19yrs
posted by techie.embedded
6 comments posted 19yrs posted by techie.embedded

How to make a GUI for embedded systems?

I'm looking for some tutorial or book that teaches how to write a GUI in C for use in embedded systems. Got any tip?
5 comments posted 19yrs
posted by BL
5 comments posted 19yrs posted by BL

Blackfin SPI slave boot mode

Does anyone have any first hand experience with the Analog Devices Blackfin SPI slave boot mode operation? I'm trying t...
4 comments posted 19yrs
posted by johnspeth
4 comments posted 19yrs posted by johnspeth

Rationale behind the Modebits

hi The mode bits of ARM7 in CPSR are of 5 bit width when the processor is capable of operating in one of the 7 modes. I...
0 comments posted 19yrs
posted by kishore.ln
0 comments posted 19yrs posted by kishore.ln

Starting Bootloader at AT91RM9200-EK

Hi Im new to ARM9 processors and have the following problem: i want to ru any executable code (that i can change) on my...
1 comments posted 19yrs
posted by lep
1 comments posted 19yrs posted by lep

Pyserial access probs

I'm mucking around with python and pyserial, and was looking for examples ( 'cos I'm not very good) From http://pyseria...
2 comments posted 19yrs
posted by mart_in_medina
2 comments posted 19yrs posted by mart_in_medina

How do I start with AVR microcontroller??

Hello everyone, I am new to avr microcontroller.Which is good online tutorial for AVR micro
6 comments posted 19yrs
posted by manishshakya.nd
6 comments posted 19yrs posted by manishshakya.nd

WLAN card to generate pulsed RF?

Hello Folks, This would address both electronics and embedded engineers. Is there a method to coax a regular built-in W...
81 comments posted 19yrs
posted by notthisjoergsch
81 comments posted 19yrs posted by notthisjoergsch

Home made programmer for PIC12C509x

Can someone advise me how to build the simplest home made programmer for PIC12C509x?
0 comments posted 19yrs
posted by albertgoodwill
0 comments posted 19yrs posted by albertgoodwill

Cypress EZ-USB FX2 port pin problem

Hi. I'm just starting to work with the Cypress EZ-USB FX2 chip (56 pin version), and the port pins are causing me troub...
2 comments posted 19yrs
posted by jetmarc
2 comments posted 19yrs posted by jetmarc

Interfacing AT91SAM9260 with cheap SRAM or SRAM?

I was hoping to only spend $1 to $2 for 32k SRAM (or SDRAM) to interface with the AT91SAM9260. Looking at the schematic...
2 comments posted 19yrs
posted by mark
2 comments posted 19yrs posted by mark

Recommendation for audio hardware

Hello. I'm looking to put together a little hard disk recorder - essentially six audio channels connected to some sort...
17 comments posted 19yrs
posted by artifact.one
17 comments posted 19yrs posted by artifact.one

Serial To Ethernet Converter

I need to remote RS232/RS485 signal over ethernet infrastructured network, which kind of device do you suggest me?? than...
5 comments posted 19yrs
posted by qwertybel
5 comments posted 19yrs posted by qwertybel