Hello NG,
i have the SAM7-P256 DEV-Board from Olimex.
But if i open and compile the mmc demo - it doesn=B4t work.
formatting link
Is there something i have to change after downloading it?
Thanks for any help.
Regards, Peter
SD / MMC on AT91SAM7S256
Aug 21, 2007
1 Replies
A quick glance shows that all chip select (CS_LOW()/CS_HIGH()) commands are commented out in MMC.c. It certainly will not work without a proper CS.
--Gene
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required