Trigger via RS232

Hi all, i need to use a Perkin Elmer Strobo lamp MVS4100

this lamp need a +5V, 20mA,10-100=B5sec pulse to be triggered via the 9pin connector.

Do you thing is somewhere avaible some hardware that i could put between the Lamp and the Personal Computer (via rs232) so i could controll by computer(via software) the trigger?.

thanks in Advance,

G=2E

Reply to
COmpa
Loading thread data ...

Sure, just take the handshake signal, DTR or RTS

Rene

--=20 Ing.Buero R.Tschaggelar -

formatting link
& commercial newsgroups -
formatting link

Reply to
Rene Tschaggelar

. If your using a frame grabber card attached to the PC, they usually have a TTL line to trigger the strobe.=20

Steve Roberts

Reply to
osr

ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.