Hi, Can any one tell me whether XTR110 V to I convereter is meant only for DC voltages or works fine wid AC voltages as well ... Regards, Asmita
Regarding XTR110 V to I converter
Apr 07, 2007
1 Replies
It's in the current data sheet from the TI web site. See the spec for "dynamic response settling time" for instance. The input voltage should be offset from zero, a suggested by figure 6 in the data sheet: if the input voltage range is 0 to 10 V for 4 to 20mA output, then you can input a 10V p-p AC signal if you bias it with +5V DC, so it swings from 0 to +10V.
Cheers, Tom
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required