I bought a couple of these 2.4ghz modules and it appears there is a lot more to getting them up and running than I thought.
It looks like I need a development board plus their X-ctu software just to configure them?
Is anyone familiar with this product and perhaps can tell me if there's a basic bare bones setup I can use to program these?
Really, all I probably need to do is set the baud rate to my desired
1200, I think they're set for a 9600 default.
I have standard 8N1 rs232 that I'll be using.
I connected ground, +5v and my data with them as is, but nothing.
Thanks for any info.