Not everyone may know this one.
Given a series string of unconnected parts, you can select the wire tool, the pencil icon, and draw one long line through all the parts to do the connections. You can even turn corners.
LT Spice Trick
Jul 01, 2023
3 Replies
lørdag den 1. juli 2023 kl. 16.40.50 UTC+2 skrev John Larkin:
you can also place a part on a wire
John Larkin has been going to too many Trump supporter rallies. The "not everyone" who doesn't know this must be a rather small proportion of the LT Spice users.
Flyguy probably wouldn't, but he doesn't seem to use LT Spice either. For somebody who posts to an electronic design user group, he posts very little about electronic design - absolutely nothing that I can recall.
John Larkin isn't much better - he does post about electronics, but nothing about designing circuits. It is more about blowing up components.
There’s a control panel setting to turn that behavior off, ie to allow straight line connections between pins.
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required