2nd last page of data sheet says there's a bump on one corner. It's only 4 pins so for prototyping you could probably just dab some paste on the pads and hot air flow it.
Read the full replyHi everyone, are there any ways to prototype with the very small DSBGA pack ages? Trying to work with a LP5560 from Texas Instruments but these chips are impossibly small (less than 1mm x 1mm). And how do you figure out whic h pin is which? There seems to be no orientation marks.
Thanks, Scot
2nd last page of data sheet says there's a bump on one corner.
It's only 4 pins so for prototyping you could probably just dab some paste on the pads and hot air flow it.
Have something to add? Share your thoughts — no account required.
Ask the community — no account required