Focused homemade nitrogen laser?

And you're going to excite this laser how? :)

--- sam | Sci.Electronics.Repair FAQ Mirror:

Note: These links are hopefully temporary until we can sort out the excessive traffic on Repairfaq.org.

Important: Anything sent to the email address in the message header above is ignored unless my full name is included in the subject line. Or, you can contact me via the Feedback Form in the FAQs.

I would expect it to be linear. However, it's not only the energy, but the timing - getting the excitation pulse to be in sync with the light pulse is not trivial over any distance.

--- sam | Sci.Electronics.Repair FAQ Mirror:

Note: These links are hopefully temporary until we can sort out the excessive traffic on Repairfaq.org.

Important: Anything sent to the email address in the message header above is ignored unless my full name is included in the subject line. Or, you can contact me via the Feedback Form in the FAQs.

I think what he means is that once the beam spreads to 25 mm.....

--- sam | Sci.Electronics.Repair FAQ Mirror:

Note: These links are hopefully temporary until we can sort out the excessive traffic on Repairfaq.org.

Important: Anything sent to the email address in the message header above is ignored unless my full name is included in the subject line. Or, you can contact me via the Feedback Form in the FAQs.

They 'could'; but given the very rapid discharge needed, it will have to be transverse excited, & either a rather complicated delay system & one spark gap, or lots of spark gaps...........

Realistically, a metre is a pain, & anything more pretty impractical.

Harvey

Do any N2 lasers have that big a gap? Maybe, but Ive not seen one.

you would only need a focal length of

with

could

meters,

length of

length,

but

light

OK, the problems with just using air at standard pressure may be insurmountable for my application.

However, this page suggests homebuilt nitrogen lasers can be used for micromachining with the lasing gas at low pressure:

The Nitrogen Gas Laser. "This laser produces intense, short, pulses of UV radiation at 337.1nm and is useful for applications ranging from microcutting to pumping dye lasers. This is one of the easiest gas lasers to build 'from scratch' although the electrical discharge circuitry must be carefully designed."

The page suggests a vacuum pump to get the nitrogen down to 25 torr, about 3% of standard pressure, is simple and low cost. This company has prices for low cost UV lenses:

UV Optics - PCX.

They give a price for a 6mm diameter, 9 mm focal length UV lens as about $5.00. This is a Hong Kong company however.

Bob Clark

nightbat

Thanks for the relative posted subject info Bob, reference links, and all additional info from contributing posters. Could be useful for possible low cost contruction of initial Star Race D.R.I.L.L.

the nightbat

What about using a reflector?

Thomas