I work as a coputer tech (fixing pcs) in a major university as part of a work study program. Im also a junior in computer engineering, so I know my way around a breadboard.
One of the machines is a newish dell btx, that's having major cooling problems (random page faults, hd temp goes up to about 130 F, etc). I narrowed the problem down to the main case fan, which is a four pin PWM (pulse-width modulation). Apparently, the bios (happens without hd/os) forces the fan to spin at a ridiculously low speed, approximately 10% of capacity. After tinkering a bit, I found that cutting the blue (PWM) wire was adequate enough to disable pwm, and forced it to 100%. But now it sound's like one of those handheld vacuum cleaners, and is likely to have a very low MFT (mean failure time). I've tinkered a bit more, and found that by grounding the pwm with a suitable resistor, it slows it down to an acceptible level. I've run a few tests, and I've come up with the following data:
Fan Power draw at 100%: ~375 mA Ideal Power draw (flow vs sound): ~210 mA
Pwm voltage (fan to ground): ~3.266 V Pwm Current (directly grounded) ~0.52 mA Ideal Pwm>Resistor>Ground: ~3.2 kOhm
I was wondering if anybody had any additional input about this before I screw something up royally. With these Ideal values, everything seems to work fine, and I don't notice any risky voltages or currents. I'm on a tight schedule, so I'm likely to begin soldering everything into place soon.
Cheers.