2.4GHz bi-directional amplifier and alt.binaries.schematics.electronic

May 16, 2006 4 Replies

I need a schematic diagram + layout for such amplifier( wlan booster delivering min. 27dBm@2.4GHz).



Or does anybody have a circuit working with CLY10/CLY5?



How can I post to alt.binaries.schematics.electronic?



snipped-for-privacy@stud.u-szeged.hu



ABSE is a pain to get too, my ISP doesn't provide it, best to stick in on your website and post a URL

I'm reasonably ignorant about wlan it seems that you need to hack into the TX/RX controls so you can control the TX/RX switch search for External PA for nRF24xx , possibly nRD24-01 on the Nordic semiconductor site. But from the same app note

If the output power is increased then it is important to ensure that your system complies with the appropriate regulations. The relevant current RF emission regulations can be found at the following: Europe:

formatting link
Unites States:
formatting link
Japan
formatting link
so +27dBm might interesting legally

martin

Get a real ISP, with a real newsserver, and use a real newsreader.

Good Luck! Rich

One old satellite dish, one USB wifi dongle, some duct tape, and a USB cable.

or One old satellite dish (80cm) one 15cm dia.Beans Tin can cut to 7cm height & inside a biQuad radiator mounted on Dish(offset) arm & some quality cable /26dBi

or One old satellite dish (60 cm) & this to drive it same way: 25dBi http://193.189.160.28/seibert/HP/BTC-bQtop.jpg http://193.189.160.28/seibert/HP/BTCbQsideFront.jpg :-)))

-- Regards , SPAJKY ® mail addr. @ my site @

formatting link
4y - "Tualatin OC-ed / BX-Slot1 / inaudible setup!"

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required