Open-source synth, sampler and sequencer in one acrylic box

Nov 10, 2026 Last reply: 5 days ago 2 Replies
Jump to replies (2)

The starting point here was a simple question: could one box hold an entire studio? Fundamental Frequency answered with the LMN-3, an open-source instrument that combines a synthesizer, a sampler, a sequencer and a compact DAW, all running on a Raspberry Pi 4. Everything from CAD files to firmware sits in public repositories, so anyone can pitch in and contribute.



The way it is put together deserves attention. A custom 2-layer PCB carries a Teensy 4.1 that pipes MIDI over USB into the Pi, where the DAW is written in C++ on top of JUCE, with Tracktion Engine handling much of the audio back end. The firmware leans on the Control Surface Arduino library, and staying on the Arduino platform was chosen to make contributing easier. Only through-hole parts are used, so no heat gun or toaster oven is needed to build one. The case is clear acrylic designed for laser cutting, with the black board visible underneath, and the whole assembly was modeled in FreeCAD.



What stands out for me are the controls: mechanical keyboard keys, four rotary encoders, an analog joystick and a color screen. The dials cover waveforms, envelopes, filters, delay, reverb and an LFO, and there is a 16-step sequencer with selectable note divisions. Timeline editing supports slice, cut, paste and undo, the joystick handles pitch bends, and finished arrangements can be rendered to an audio file.



One open question remains: the maker is hesitant about whether the DAW runs on a Pi 3, so lower-spec machines are unproven for now. The screen also consumes every GPIO pin, leaving zero spare. Roughly a year of nights-and-weekends work got it this far, after a first prototype whose poor construction the maker underestimated, and a redesign that is considered a big step forward.



Project by Fundamental Frequency. Watch it on their YouTube channel:

formatting link


Going through-hole for the entire board seems like a really smart call. It drops the assembly bar way down, since a basic iron is all that is needed, which suits an open-source project where strangers build your design. The trade-off is board space, though the custom PCB still kept the footprint small.

Since the maker is unsure about Pi 3 support, a concrete next step could be benchmarking the DAW under the software emulator first. That emulator already exists for developing without owning the hardware, so it looks like a low-risk way to probe performance limits before anyone wires up an older board and finds out the hard way.

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required