Driving H-Bridge for DC motors with RC servo signals

Do you have a question? Post it now! No Registration Necessary

Translate This Thread From English to

Threaded View


Radio control (RC) servo motors are controlled with pulse sequence of 1-2ms
in length where 1ms pulse corresponds to left max position, 1.5ms to center
position and 2ms corresponds to right max position.

http://www.veetail.com/HowRCworks.shtml
http://adamone.rchomepage.com/guide1.htm
http://www.seattlerobotics.org/encoder/200106/16csscnt.htm

I want to use RC pulses for speed control of a 10-15Amp 12-24v brush type DC
motor.
Is there any schematics (and low cost kit) for this application ?





Re: Driving H-Bridge for DC motors with RC servo signals



Quoted text here. Click to load it

    Just buy a good reverseable R/C speed control like the Novak XRS.

http://www.shopatron.com/product/product_id=NOV1830/135.0.5995.4995.0.0.0

    Rated for 40 amps, although only at 6V.  Novak has bigger speed
controls (to 400 amps!) at higher voltages.


                John Nagle

Re: Driving H-Bridge for DC motors with RC servo signals


http://www.cpg1.freeserve.co.uk/servos/servos.htm



Site Timeline