This brandnew VCR has a few problems: +12V, +5V and + 28V present No display, no sound, no pic All fuctions acting weard, no reverse or rewind. In PB with tape running the RF ANT Prog shows on RF out and SCART. Power ON/OFF does not function, Eject does not function, except when mains powercord is cycled....but the Mainboard, Mechanics and Frontpanel still looks superb !!
running the
function, Eject
assuming the mode switch is not defective, there could be a short or other problem somewhere in the control circuitry (like possibly a screw floating round? !)Multiple system problems lie this can be caused by the power supply, but here, that would not appear to be the case.... corrupted eeprom-.? check also front panel controls and components.
-Ben
ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.