Re: [FoxNews]A small town's sudden power surge fried tech gear in hundreds of homes

Feb 10, 2017 1 Replies


>>


>>> snipped-for-privacy@world.std.spaamtrap.com (Michael Moroney)
>>> news:o7fjft$sj3$ snipped-for-privacy@pcls7.std.com Wed, 08 Feb 2017 17:11:25 GMT >>
>>>> Up the street from me, they upgraded a MV distribution circuit
>>>> from a lower voltage to a higher one (13,800V I believe).
>>
>>> Have they been adding on to the circuits in your area? New buildings,
>>> etc? What was the previous voltage?
>>
>> No new construction/new loads in that area. It may have been done to
>> allow that circuit to provide an additional 13.8K feed to a medical center
>> a ways upstream. I am uncertain of the old voltage but the nameplate for a
>> regulator transformer on a nearby old circuit reads 2400V which seems kind
>> of low. The utility seems to have been upgrading other older/lower voltage
>> circuits in the area as well.
>
>In my neighbourhood the top line is usually 1600V, with one or a few
>pole pigs per block to make 120-0-120V. Of course we're about half a
>mile from the substation.
>
>Cheers
>
>Phil Hobbs

The top line running down my street is 7200 volts. Maybe that's because I live in a rural area. It seems high to me but the guy from PSE told me that it is not unusual, at least where I live. Eric

Interesting, they run 7200 V here. I read the plate on a transformer when it was down on the ground for replacement.

So, anybody know how the folks in Brookville are getting their lives back together? With the burned siding and meters in some pictures, I doubt much electrical in those houses survived. Everything from light bulbs to the breaker panels and in-wall wiring might need to be replaced. I guess electrical contractors are going to be busy for some time.

Jon

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required