Hello all,
I am an electronics hobbiest...and like to pursue challenges!
I accidently put a 5+vdc power surge on my two speaker wires inside th TV set. Since then, I have had no sound on the TV, but everything els is OK.
I am sure I messed up the audio section somehow...but do not know wher to start. My 33 ohm/2 watt resistor is OK in the audio section...bu that is all I see (visually) that could of been messed up.
I would sure appreciate replies concerning my challenge. I have an 0h Meter/desoldering gun/and tools to do the job...but do not know wher the culprit is lurking.
Any help would very much be commended.
I thank each and everyone for taking the time to read my post!
Sincerely,
Patrick C. Cambr
-- braincambre500