Heating element for Black&Decker

Hi,

Have a "just out of warranty" toaster oven: Black&DeckerTRO5900CT. It has 4 identical heating elements. One is gone. They are 12" and are straight.

Has anyone heard of a source for these? The are welded to wires, so it appears they are not meant to be replaced, but it's easy for me to do, if I can find one. Hate to toss and otherwise good appliance.

Regards,

RichK

We are a throwaway culture. Our next generations will have to figure out how to repair the landfills. They might not speak kindly of us.

Didn't know B&D mad ANY good appliance or tool.

Mike D.

From a similar toaster.

The trash, or:

Buy a similar or identical one, and when it breaks, you'll have at least 3 good elements to repair the current one.

if

You're just not old enough. Was a fine company years ago.

Al

Call B&D. "It's a bit less than a year old..."

They will tell you to cut off the plug and send it to them. When they get the plug, they'll send you a new oven.

I've done this three times with the B&D Spacemaker coffee pot. Finally sold on eBay the last one they sent and got a Mr Coffee ($9.89 at WalMart) and a appliance timer ($6.59 at Radiio Shack).

I sometimes buy two or three of something. Once they all die I start using parts from the others to keep one going. Funny old world.

My very first electric drill is a B&D and still works fine - dated 1963. It did have a factory overhaul in the '70s, though.

My first electric drill was a Skil 3/8" single speed model that I bought in the Navy Exchange in Norfolk VA just before ending my enlistment in 1967. I built an SCR speed controller for it a few months later from a construction article in Popular Electronics magazine. Both still work flawlessly. It has outlasted four B&D variable speed drills.

You're absolutely right, though, in that B&D is no longer the manufacturer they once were, but for that matter, neither is Skil. Hang onto your old tools... they don't make 'em like they used to.

But ISTR that first drill costing a week's wages. You can buy one for less than an hour's now.

You're right.

Heh heh. Now that's a poor B&D product by all reports - their sabre saw.

The last B&D thing I bought was a fairly expensive router. Not top of the range, price wise, but not cheap either. Previously a Tradesman drill and circular saw which are still excellent.

The router packed up with a seized bearing after not that much use but out of warrenty. The plastic cooling fan had melted. The fan is part of the armature...

No more B&D for me.

I remember an instructor saying:

"It is estimated that over a million quarter-inch drill bits are sold in this country every year. Interestingly, not one buyer WANTED a quarter-inch drill bit!

"What every single buyer wanted was a quarter-inch HOLE!"

The instructor was teaching the Dale Carniege Sales Course.

If they really wanted 1/4" holes, they also needed a good micrometer to make sure the drills were actually 1/4".