I recently had a problem with my programmer at my work place. I installed the boot disk in the 3.5 disk drive and turned on the programmer and I got a boot disk error. I tried a couple of more times, same thing. I called Data I/O and they said the 3.5 floppy dirve was bad. I found another 2900 on ebay. The programmer from ebay boots up and works fine. However, I am using a much older revision boot disk. I am looking for some one that would allow me to make a copy of a 2900 series, 6.50 revision or higher boot disk and algorithms. I have called DataI/O and they do not support the 2900 or sell 3.5 floppies any more. If there is someone out there that could help I would appreicate very much.
Data I/O 2900 Programmer
Dec 14, 2006
1 Replies
I recently had a problem with my programmer at my work place. I installed the boot disk in the 3.5 disk drive and turned on the programmer and I got a boot disk error. I tried a couple of more times, same thing. I called Data I/O and they said the 3.5 floppy dirve was bad. I found another 2900 programmer that boots up and works fine. However, I am using a much older revision boot disk. I am looking for someone that would give me a set of a 2900 series, 6.50 revision or higher, boot disk and algorithms. If there is someone out there that could help I would appreicate very much.
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required