Maker etc? On a 2006 German Dynacord mixer amp. I've not seem them before, no name on the exposed parts of the connector. 0.1 inch pitch ribbon.
views of connectors , same, both ends of the ribbon for photoing convenience. top as found, pcb part, ribbon part internals Black end pieces are just locators and for polarising,different sizes/recesses, not gripping the white bits. Locking is done internally somehow. Anyone know the professional way of unmaking these connectors? you do not umake the second IDC connection, per pin, in the process of separating. I ended up using a knife blade and then jeweller's screwdriver to get purchase between pcb and white part that goes down to pcb level, lacquer damage can be seen in middle view. Perhaps a dentists sickle probe as a lever into the small holes along the white part edge.
-- Diverse Devices, Southampton, England electronic hints and repair briefs , schematics/manuals list on