10 discussions on ElectronDepot about the Atmel SAM7X: what owners asked, what went wrong, and what fixed it.
We have a product based around the PIC18F6680 which is now becoming arare and expensive part. Since it looks like ARM devices are winningthe popularity war, the chips are cheap and plentiful. The questionis, with so many vendors and parts...
Hi - I'm fairly certain I'm going to use an ARM in a project I'mworking on. I have a good deal of experience with Atmel AVRs, but Ihave never used an ARM before. So I was wondering if you all couldanswer a couple basic questions regarding...
Hi All,Here is a open-source CableServer replacement,ent for Impact. CurrentlyParallel III and Alter ByteBlaster are supported, but any 3rd party canbe implemented easily and can be used from Impact.I've tested only Impact 8.2, if anybody...
Hi,I've recently started development with a Philips LPC2103. I know Atmel has a site, which I found useful for AT91SAM stuff. I'm looking for suggestions or recommendations on websites/forums that discuss using the LPC21xx parts. I did...
Witam!Szukam czegoś ułatwiającego życie do AT91SAM7S. Najbardziej zależy mi na czymś w rodzaju mini systemu operacyjnego (potrafiącego zarządzać wątkami) oraz obsługą peryferiów.Zerknąłem na FreeRTOS ale o ile dobrze widzę...
I need to produce an Ethernet-capable embedded device (includingTCP/IP stack) for about $50 in low quantities (think perhaps qty 100).I can get a 2-layer board in these quantities for $13, so that leavesonly about $40 for everything that...