Embedded Programming

  1. Home
  2. Embedded Programming
16393 Threads Posts
to

Worth reading in Embedded Programming

Power supply in automotive environment

Sadly, I'm running up against the limits of my meager mixed-signal design knowledge. I'm trying to put together an embe...
7 comments posted 22yrs
posted by jamcguir
7 comments posted 22yrs posted by jamcguir

CS8900 and full duplex

I am using the CS8900 in a design and it works very well except I have one problem. Switches don't recognize full duple...
4 comments posted 22yrs
posted by fly_135(
4 comments posted 22yrs posted by fly_135(

embedded dialup and GPRS soultion

Just released a new set of docs for the uNetSerial platform. Schematics and board layouts have been released. You can n...
0 comments posted 22yrs
posted by mike
0 comments posted 22yrs posted by mike

Development hardware and PICMG SBCs - some free

Hi all, I'm cleaning my closet, and I found some stuff that I've put up on ebay and some that I'll give away "free to g...
1 comments posted 22yrs
posted by larwe
1 comments posted 22yrs posted by larwe

Info on CAN Protocol please

Hi - I am studying Engine Management systems and would like to know where I could find help with programming for the CA...
7 comments posted 22yrs
posted by James
7 comments posted 22yrs posted by James

USB 2.0 on PowerPC SBC

Hi Does anyone know of any reasonable cost PowerPC SBCs with on-board USB 2.0? On my searches I've found two or three l...
0 comments posted 22yrs
posted by john
0 comments posted 22yrs posted by john

Annoucement -NEW Software Debugger for ARM

Announcing to the Embedded Community across the world, the arrival of a Software debugger that is an across the board t...
2 comments posted 22yrs
posted by sales
2 comments posted 22yrs posted by sales

schematic of BDM multilink cable

Dear, I am looking for the schematic of the BDM multilink cable. I need this because I want to program my Motorola HCS1...
2 comments posted 22yrs
posted by bgaerdelen
2 comments posted 22yrs posted by bgaerdelen

Help with small kernel..

Hi, I'm writing a little "kernel" for a small microprocessor. Right now it just implements tasks, and does scheduling....
13 comments posted 22yrs
posted by noselasd
13 comments posted 22yrs posted by noselasd

4k limit of IAR's MSP430 C compiler

IAR's C compiler has a code generation limit of 4k, for individual modules this would not be a problem for me. However...
5 comments posted 22yrs
posted by michael
5 comments posted 22yrs posted by michael

Speaking of small packages...

I have been looking at the newest logic in the smallest packages and it seems there is a bit of non-conformity between...
1 comments posted 22yrs
posted by noone
1 comments posted 22yrs posted by noone

16F876 pulls

Hi Group, I have a few dozen 16F876 20Mhz 28 pin dip flash microcontroller. These are removed from products that are re...
0 comments posted 22yrs
posted by pdrunen
0 comments posted 22yrs posted by pdrunen

CS8900 dev boards

Hi folks, We are contemplating using a CS8900 ethernet MAC/PHY chip in a project (interfacing to an FPGA-based soft-cor...
8 comments posted 22yrs
posted by jwilliams
8 comments posted 22yrs posted by jwilliams

worldwide access to ARM7 board

http://203.218.182.24:4040 assigned to dynamic IP if too people many coming in, I may reset the whole system. http://ar...
3 comments posted 22yrs
posted by LPC_2106
3 comments posted 22yrs posted by LPC_2106