PIC16F57

Aug 11, 2005 1 Replies
T

Hi I am looking for help with programming 16F57 pics. I have tryied the Altronix AL1700 and made a serial adaptor for the PICALLW programmer but to no avail. I am getting the following error messages using the the AL1700:



Program Memory is code protected. Reprogram the entire part. If "Auto select memory areas and range" on the Memory Ranges tab of the programmer settings is enabled, it must be disabeled before proceeding.



I have tried changing the code prot flg to no avail.



Now tried 3 parts and all respond the same


Can anybody offer any help?



Vote
Twitter Facebook LinkedIn
J

Sounds to me like the IC's have the code protection bit set and the programmer is giving you an error based on some conflicting setting you have set in the programmer software. You said you tried changing the "code prot flg" (I take it you mean you played with your source file), did you try, "If "Auto select memory areas and range" on the Memory Ranges tab of the programmer settings is enabled, it must be disabeled before proceeding" ? It looks like it is giving you a clue there.

Jim

Vote
Twitter Facebook LinkedIn

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required