Do you have a question? Post it now! No Registration Necessary
- Ken Taylor
November 30, 2005, 7:48 pm
rate this thread
Get a copy of the data sheet such as at:
it is detailed. The PCB your device is soldered to appears to be just a DIP
carrier, which should make it relatively easy to connect to.
This site has a few more resources that may be of use:
as is this:
- » Replacing NiCd batteries in an obsolete Uniden UH-052XR radio?
- — Last Updated thread in » Electronics Down Under
- » Are there any ST 32F417 / Cube IDE / STLINK / C developers on here?
- — The site's Last Updated Thread. Posted in » Embedded Programming