10 discussions on ElectronDepot about the Lattice ECP3: what owners asked, what went wrong, and what fixed it.
Gentlemen, An upcoming audio project will be fairly math-intense. Two 1024-point complex FFTs at least at 5msec rep rates (FFTs will be overlapping), phase calculations on-the-fly, another slower FFT (or a scanning Goertzel) to determine a...
Hallo zusammen! Als Oszi-Neuling bin ich von den Möglichkeiten dieses Universalwerkzeugs begeistert. Allerdings bekam ich heute etwas zu sehen, das ich mir nicht erklären kann. Gemessen habe ich ein Pin eines Arduino, das mit ca. 38 kHz...
Gowin seems to have some nice configuration modes in their parts. Of cours e they have an auto boot from internal flash and JTAG can be used to progra m either the RAM or the Flash. They also have master and slave SPI modes, a serial...
here it is:1) devices densities like in Spartan-3 (50..5000)2) devices packages like Spartan-3E (including QN132 !) or better(microBGA 6x6 mm?)3) all good features of S3A/AN !!4) design security with OTP encryption key (like Lattice ECP2)5)...
Hi,I'm looking for an FPGA-based PCI Express development board which iscapable of transmitting data at about 1.4 GByte/sec to the hostcomputer (PCIe Gen1 x8 or Gen2 x4/x8).Further considerations:1. included IDE license2. included PCIe IP...
Hopefully not sparking any religious wars here, but hoping for someadvice from those-who-know :)I switched to using Altera's software a couple of years ago, becauseit felt more intuitive to me - probably a personal thing, but it justgrocked...