Embedded Programming

  1. Home
  2. Embedded Programming
16390 Threads Posts
to

Worth reading in Embedded Programming

Defining "firmware quality"

I've read "The Non-Quality Revolution" by Jack Ganssle @ Embedde.com (http://tinyurl.com/y9tspzl). What about the conce...
10 comments posted 16yrs
posted by grgmeda
10 comments posted 16yrs posted by grgmeda

USB Host

I have to develop an application, as well as management of certain I / O I must read data from USB key external (USB ho...
9 comments posted 16yrs
posted by blasiis
9 comments posted 16yrs posted by blasiis

Can't load boot file

Hi, I have used sysNvRam function to write data on Ram of VxWorks. After executing that function on VxWorks. VxWorks sy...
0 comments posted 16yrs
posted by vpatel
0 comments posted 16yrs posted by vpatel

RS-485 Unterminated Bus and bias resistors

After looking at several application notes (by National, TI, B&B Electronic...) I can't understand if I can bias the tw...
5 comments posted 16yrs
posted by grgmeda
5 comments posted 16yrs posted by grgmeda

Embedded C++ Book?

Any book recommendations for C++ techniques for deeply embedded systems? I know how to do this, but I kind of picked it...
18 comments posted 16yrs
posted by tim
18 comments posted 16yrs posted by tim

Auto-update protocol

Hi, I'm looking for ideas for a lightweight (yet robust) autoupdate protocol for a family of network clients I'm design...
34 comments posted 16yrs
posted by not.going.to.be
34 comments posted 16yrs posted by not.going.to.be

New Rabbit 6000 Microcontroller has on-board WiFi

http://microcontroller.com/news/Rabbit_6000.asp Supports 802.11 a/b/g ON-CHIP, and runs at 200MHz Article contains a blo...
2 comments posted 16yrs
posted by contact01
2 comments posted 16yrs posted by contact01

SDHC 4 bit driver?

Hello, I'm trying to add SDHC support to a STM32 4 bit mode driver (not SPI) which works fine with normal SD. Before AC...
2 comments posted 16yrs
posted by ded1549TOGLIMI
2 comments posted 16yrs posted by ded1549TOGLIMI

Extended Hamming encode/decode

I needed to write some very simple c routines (tempted to use assembly, but not for this application at this time) to h...
72 comments posted 16yrs
posted by jonk
72 comments posted 16yrs posted by jonk