The Pacific Measurements PM1038 and the TEK5103N scope mainframes use the same display unit, the D11, for single beam storage.
The 5103N mainframe manual refers to a 'display unit' manual, though all hardware is captive. Can anyone provide a schematic for the D11 display unit?
The PM1038 backplane ( the 'interface circuit') differs from the one used in the 5103N; identified as PM ASSY 12453 in the artwork. Does anyone have info on this assembly?
RL
I don't have the 5103/D11 drawings, but I used too.
CTR Surplus in Crestline Ohio has piles of Tek XY storage displays and non storage xy, in both the green and photographic violet phosphors. A few of them have been rebranded by PM. They are removed from Medical Gear. In both working and nonworking order. Sometimes missing side panels, but electrically intact. Nonworking is usually somebody has just messed with the offsets. Few of them are the D11 frames, but you might find a useful set of parts there. I'm posting this to help keep my favorite surplus place alive in this economy, as its gonna be a long while before I can buy from them again.
Steve Roberts
Have something to add? Share your thoughts — no account required.
Ask the community — no account required