Some colleagues and I were discussing the situation with the high techindustry, with jobs moving out of North America. This has hit circuitdesigners hard, especially those in digital. Can EDA tool developmentbe expected to follow suit, is has it already happened? If not, whatare the factors that differentiate it from design work to make it lessexportable? Comments are also welcome for automatation of methodologiesfor programmable system-on-chip e.g. reconfigurable processor arrays.

techcircuitdevelopmentlessmethodologiesSorry bud but its already gone offshore big time, Romania, Russia,India all have EDA sites now, read EET to see who is doing theshipping. I long lost interest in EDA except to create own stuff. TheEDA biz was always less profitable than the customer base so its nosurprise.regardsjohnjakson_usa_com

Exportability of EDA industry from North America?

Dec 16, 2004 41 Replies

Rate this thread:

Spehro Pefhany 21 years ago

If you're getting lousy service, perhaps it's in Vientiane.

Vote

Tobias Weingartner 21 years ago

And no US citizens speak french, and happen to work at a call centre in the states? In today's world, it helps not to have any notions about where you are getting service from. Wheater state, or country, or even company.

[100~Plax]sb16i0A2172656B63616820636420726568746F6E61207473754A[dZ1!=b]salax

Vote

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required